TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 661 of 783

TM 9-2350-260-20-1-3

TRACK SUPPORT ROLLER REPLACEMENT (Sheet 6 of 11)

20. Using hammer, tap around deflector (Q) to free it

and seal (R).

21. Using screwdriver, pry deflector (Q) and seal (R)

from axle as shown.

22. Remove deflector (Q) and seal (R) from axle.

Throw

seal away.

23. On left front support roller ONLY, using 3/16 inch

alining punch and hammer, tap around edges of

plug (S) until plug can be pried free with screwdriver.

NOTE

If plugs in steps 23 and 24 cannot be

removed as written, drill a hole in one

or the other plug and use a 1/2 inch

rod to punch out plug.

Replace plug

which has been drilled.

24. Using hammer and 3/8 inch punch, drive two spring pins (T) and other plug (U) out of axle.

Throw pins away.

25. Using hammer and 3/8 inch punch, drive pin (V) out of other axles Throw pins away.

26. Using mechanical puller (Figure F-5, Appendix F) and slide hammer puller (Item 12, Chapter 3, Section I), remove

axle (W).

Go on to Sheet 7

TA147840

14-39