TM 9-2350-260-20-1-3
TRACK SUPPORT ROLLER REPLACEMENT (Sheet 8 of 11)
6.
On other support rollers, using hammer, tap new spring pin (D) through hole in housing and axle (A).
7.
Make sure spacer (E) is correctly installed on axle (A).
NOTE
Open groove of deflector (F) and lip seal (G)
must face outward.
8.
Mount deflector (F) and new seal (G) over axle (A).
9.
Using hammer and special replacer tool (Item 21,
Chapter 3, Section I),tap deflector and seal into place.
10. Pack inner bearing cone (H) with grease (Item 36, Appendix D).
11. Pack outer bearing cone (J) with grease (Item 36, Appendix D).
Go on to Sheet 9
TA147842
14-41