TM 9-2350-260-20-1-3
SUSPENSION TORSION BAR REPLACEMENT (Sheet 6 of 7)
6.
Using crowbar (or pinch bar), apply upward pressure
to support arm (B) until blind spline on bar (A) and
index marks on support arm (B) are alined.
7.
Using slide hammer puller (Item 12, Chapter 3,
Section I) and adapter (Item 6, Chapter 3, Section I),
push end of bar (A) in as far as it will go.
Remove
blocks and crowbar.
8.
Remove slide hammer and adapter.
9.
Apply grease (Item 36, Appendix D) to end of bar
(A).
10. Using adjustable wrench with special wrench (Item 26, Chapter 3, Section I), screw end plug (C) and spacer (D) into
place.
Remove special wrench.
12. Using deep socket with ratchet, tighten screw (F).
11. Secure spacer (D) and end plug (C) with new
lockwasher (E) and screw (F).
Go on to Sheet 7
TA147830
14-29