TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 650 of 783

TM 9-2350-260-20-1-3

SUSPENSION TORSION BAR REPLACEMENT (Sheet 5 of 7)

1.

Apply grease (Item 36, Appendix D) to splined ends

of torsion bar (A).

2.

Fill outer end opening with grease (1/4-inch deep).

3.

Insert unmarked end of bar (A) into roadwheel

support arm (B) housing.

4.

Rotate bar so that index mark is at top.

5.

Push bar (A) through housing until inside end enters

anchor on other side of tank.

When this is done,

about 1/2 inch of bar will be out of housing.

Go on to Sheet 6

TA147829

14-28