TM-9-2350-260-20-1-3

TANK, COMBAT, FULL TRACKED 105-MM GUN, M60 2350-00-678-5773 (HULL)

TECHNICAL MANUAL; ORGANIZATIONAL MAINTENANCE VOLUME 3 OF 4 CHAPTERS 10 THRU 15

TM-9-2350-260-20-1-3 - Page 675 of 783

TM 9-2350-260-20-1-3

COMPENSATING IDLER WHEEL AND ROADWHEEL REPLACEMENT (Sheet 4 of 4)

9.

Using 1-9/16 inch socket with extension and hinged

handle, remove 10 nuts (A) and flat washers (B)

securing roadwheel (C) to wheel hub (D).

10. Using second person for help, pull one roadwheel,

then the other, off mounting studs.

Do not damage

studs.

CLEANING AND INSPECTION:

1.

Replace worn-out wear plates (page 14-60).

2.

Inspect and clean mounting hub surface with wire

brush and rag prior to mounting roadwheels.

INSTALLATION:

NOTE

Do not damage hub mounting studs

when installing roadwheels.

1.

Position inside roadwheel (C) with wear plate (E)

facing out.

2.

Position outside roadwheel (C) with wear plate (E)

facing in.

NOTE

There is split wear plate (E) on each roadwheel (C).

3.

Install 10 flat washers (B) and nuts (A).

4.

Have second person back tank up so lifting arm can

be removed.

5.

If track was removed or disconnected, replace or

reconnect (TM 9-2350-260-10).

6.

Using 1-9/16 inch socket wrench with extension and

torque wrench, tighten nuts (A) to 375-385 lb-ft

(506-521 N

•

m).

End of Task

TA147854

14-53