TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 178 of 1008

TM 9-2350-261-20-2

REPLACE GENERATOR FIELD SWITCH — Continued

0232 00

INSTALLATION

WARNING

Adhesive, primer, sealant compounds, and isopropyl alcohol are toxic and flammable. These

compounds are toxic to eyes, skin, and respiratory tract. Continued exposure can make you

dizzy and irritate your eyes and throat.

Always use in well ventilated areas, away from heat, sparks, and flames. Do not breathe fumes.

Do not allow into contact with skin and eyes. Use goggles or face shield and protective gloves.

NOTE

New switches do not require pipe plug and washer. Earlier switches may have a threaded hole

that should be sealed with a pipe plug and washer to prevent fuel from leaking out. If there is a

pipe plug without a head, it can be installed too deep causing the switch to short out. Reuse old

pipe plug and washer if you get an older style switch.

1.

Coat threads of switch (2) with sealing compound.

2.

Install switch (2) on tee (3) on secondary fuel filter (4).

3.

Connect circuit 1A/1Blead(1)toswitch(2)

.

FOLLOW-THROUGH STEPS

1.

Check operation of field switch.

2.

Install rear power plant access panel (see your -10).

END OF TASK

0232 00-2