TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 184 of 1008

TM 9-2350-261-20-2

REPLACE GENERATOR DRIVE BELTS (200 AMP GENERATOR ONLY) — Continued

0234 00

INSTALLATION

1.

Install new drive belt (1) on drive pulley (2) and generator pulley (3).

2.

Turn turnbuckle (4) and tighten belt until belt deflection at midspan is 1/2 to 5/8 inch (13 to 16 mm) when force is

applied.

3.

Tighten locknut (5) on rod end (6).

4.

Tighten two screws (7) on generator mounting bracket.

FOLLOW-THROUGH STEPS

WARNING

Wearing loose clothing around moving parts can allow personnel to get caught and could result

in injury or death. Tuck in loose clothing.

1.

Start engine (see your -10). Check that generator drive belts are installed properly.

2.

Stop/shutdown engine (see your -10).

3.

Install power plant rear access panels (WP 0431 00, WP 0432 00, and WP 0433 00).

END OF TASK

0234 00-2