TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 195 of 1008

REPLACE STARTER — Continued

8.

Remove two of three bolts (12) and lockwashers (13). Discard lockwashers.

9.

Thread two steel rods into bolt holes.

10. Remove third bolt (12) and lockwasher (13). Discard lockwasher.

11. Slide starter (4) with solenoid (8) and gasket (14), if installed, down bars so it can be removed. Discard gasket.

CLEAN, INSPECT, AND REPAIR

1.

Check starter drive teeth. Remove burrs. Replace starter that has damaged teeth or teeth worn beyond original shape.

ALTERNATE INSTALLATION

1.

Install new gasket (1) on engine (2).

2.

Slide starter (3) with solenoid (4) on steel rods up to the flywheel. Secure with one new lockwasher (5) and bolt (6) to

hold in place.

3.

Remove two steel rods from threaded holes and install remaining two new lockwashers (5) and bolts (6). TIGHTEN

ALL THREE BOLTS TO 137-147 LB-FT (186–200 N·M) TORQUE. Use torque wrench.

023600-5

0236 00

TM 9-2350-261-20-2