TM-9-2350-261-20-2

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; UNIT MAINTENANCE MANUAL - VOLUME 2 OF 4

TM-9-2350-261-20-2 - Page 470 of 1008

TM 9-2350-261-20-2

REPLACE BATTERY LEADS (M1064 ONLY) — Continued

0300 00

INSTALLATION

1.

Place terminal lugs (4) on battery (7). Secure with screw (6) and nut (5).

2.

Place jumper lead (2) on two screws (3) of terminal lugs (4). Secure with two nuts (1).

NOTE

Install circuit 6 and 48 positive leads before installing circuit 7 ground lead. Instructions for

installation are the same.

3.

Install circuit 7 lead (8) as follows:

a.

Place lead (8) on hull mount. Secure with screw (9), two washers (10), and nut (11).

b.

Install new grommet (12) in battery compartment. Route lead (8) through grommet into battery compartment.

c.

Place lead (8) on screw (3) on terminal lug (4) and secure with nut (1).

4.

Coat tops of four battery terminal lugs with grease.

CAUTION

Battery cells can be damaged if the batteries are hooked up incorrectly. Make sure batteries

are hooked up correctly.

5.

Push in drawer (13) and turn handle to secure.

FOLLOW-THROUGH STEPS

1.

Turn MASTER SWITCH to ON. Check BATT- GEN gauge on instrument panel. Gauge should read in green or yellow

zone (see your -10).

2.

Start engine (see your -10).

3.

Raise and lock ramp (see your -10).

4.

Stop/shutdown engine (see your -10).

END OF TASK

0300 00-4