TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 157 of 785

TM 9-2350-261-34

REPLACE TRANSFER GEARCASE PULLEY (M577A2 WITH 200 AMP

GENERATOR ONLY) — Continued

0018 00

INSTALLATION

1.

Install new seal (8) on drive bearing plate (9).

2.

Installsnapring(10)

,tworetaining rings (11), two bearings (12), and spacer (13) on drive bearing plate (9). Use

retaining ring pliers and snap ring pliers.

3.

Install plug (6) and drive pulley (7) on drive bearing plate (9).

CAUTION

Align oil hole in housing with oil hole in case.

4.

Install new preformed packing (5) and shim (4) in transfer gearcase(3)

.

FOLLOW-THROUGH STEPS

1.

Install generator drive belt (see your -20).

END OF TASK

0018 00-2

5.

Align drive pulley assembly on transfer gearcase (3). Secure with four new key washers (2) and cap screws (1).

TIGHTEN SCREWS TO 252-300 LB-IN (28-33 N·M) TORQUE. Use torque wrench.