TM-9-2350-261-34

CARRIER, M113A2, M577A2, M1064, M1068, M1059 AND M901A1

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE MANUAL

TM-9-2350-261-34 - Page 164 of 785

TM 9-2350-261-34

REMOVE/INSTALL TRANSFER GEARCASE — Continued

0019 00

11. Connect differential oil hose (10) to elbow (11).

12. Install turnbuckle (3) on idler arm bracket (9). Secure with screw (8) and nut (7).

NOTE

When replacing generator drive belts, replace in matched sets only.

NOTE

There can be different generator components on transfer gearcase. Refer to TM 9-2350-261-20

for 200 amp generator maintenance components.

13. Install two generator drive belts (4) on generator pulley (5) and transfer gearcase pulley (6).

NOTE

Check alignment of generator pulley with transfer gearcase drive pulley. If necessary, position

generator bracket until pulleys are aligned within 1/8 inch (3 mm).

14. Turn turnbuckle (3) to the right until belt deflection at midspan is 1/2 to 5/8 inch (13 to 16 mm) when measured with

machinist rule.

15. Tighten locknut (1) on rod end (2).

001900-7