TM-9-2520-215-34

CROSS-DRIVE TRANSMISSION ASSEMBLY

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

DECEMBER 2005

TM-9-2520-215-34 - Page 255 of 508

TM 9--2520--215--34

0049 00--7

OUTPUT REDUCTION GEAR BRAKE HUB ASSEMBLY REPLACEMENT –

CONTINUED

0049 00

INSTALLATION – Continued

NOTE

Note position of notches relative to scribe mark opposite lifting hole.

6. Install stationary cam ring assembly (6) indexing pin (18) with indexing notch.

7. Install compressor assembly and compress stationary cam ring assembly (6) until snap ring groove (19) is clear.

Install new snap ring (8) in groove. Remove compressor assembly.