TM-9-2520-254-34
TRANSMISSION, AUTOMATIC, ALLISON, MODEL TX100-1
TECHNICAL MAUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL
OCTOBER 1971
TM-9-2520-254-34 - Page 62 of 126
Figure 5-36
Figure 5-34
Figure 5-37
Figure 5-35
Install lifting eye 4910-673-3801 (10865773) (A)
into end of turbine shaft (B). Using hoist (C),
remove turbine shaft (B), high-range clutch
assembly, and intermediate- and low-range sun
gears as a unit.
Install lifting eye 4910-673-3801 (10865773 (A)
to compress intermediate, low, and reverse clutch
pack. Remove two special bolts 4910-572-8701
(8356186) (B) (one each side) securing Clutch
packs.
Remove intermediate clutch anchor pin (A) by
prying under its inner end with a small screwdriver.
Remove two spacers (A).
NOTE
Special bolt 4910-572-8701 (8356186)
(B) securing clutch pack (C) is seen
through power takeoff opening.
5-12
Back to Top
