TM-9-2520-254-34
TRANSMISSION, AUTOMATIC, ALLISON, MODEL TX100-1
TECHNICAL MAUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE MANUAL
OCTOBER 1971
TM-9-2520-254-34 - Page 64 of 126
Figure 5-43
Figure 5-42
Figure 5-40
Figure 5-41
Remove intermediate back plate assembly (A).
Remove two internal-splined plates (B) and two
external-tanged plates (C). Remove intermediate-
range ring gear (D), and remaining inter nal-splined
late (E) and apply plate (F). Remove in -
termed iate-range clutch piston housing (G)
piston assembly.
and
Remove three external-tanged plates (A), three
intern al-splined plates (B), and apply plate (C).
Remove snap ring (D) securing intermediate
carrier (E) in low-range ring gear (F). Remove
intermediate carrier (E).
Position remaining assembly with output shaft (A)
up. Remove wire-type locating snap ring (B) from
output shaft (A). Remove snap ring (C) securing
reverse sun gear (D). Remove reverse sun gear (D),
splined thrust washer, and spacer (under sun gear).
.
Remove low-range planetary assembly, ring gear
(A). and reverse sun gear shaft (B) from reverse
clutch assembly (C). Remove snap ring (D).
Remove reverse sun gear shaft (B) from ring gear
(A).
5-14
Back to Top
