TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 280 of 933

TM 9-25200-270-34

14. INSPECT STEERING ARM ASSEMBLY (1)

FOR BINDING.

a. If assembly (1) moves freely in ball

slot (2) and connecting link (3) moves

freely in slot (4), go to END OF TASK. If

not, go to step 15.

15. REPAIR CONTROLLER STEERING

CONTROL ARM, page 3-46.

CAUTION

Two types of controllers exist. Do not install

an HMPT 500-3 controller on an HMPT 500

transmission. Damage to equipment can

occur.

Do not set controller on workbench top side

up. Keep hands free of internal controller

parts. Use care when setting controller down

to prevent damage to controller parts.

16. REMOVE PLUG (5).

a. (H) Hold controller assembly (6) on side

during removal of plug. (5).

b. Using 3/8-inch drive ratchet handle and

5/16-inch socket wrench attachment,

remove plug (5) and preformed

packing (7). Discard packing.

c. Repairer and helper place controller

assembly (6) on workbench bottom side

up.

3-36

Change

3