TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 277 of 933

TM 9-2520-270-34

2. REMOVE FOUR SCREWS (1) AND

LOCK WASHERS (2). DISCARD

LOCK WASHERS.

NOTE

Filter element may be found either on cap or In

hole.

4.

5.

REMOVE FLUID FILTER ELEMENT (5).

a. Pull element (5) from cap (3)

or hole (6).

b. Cover hole (6) with clean rag.

REMOVE AND DISCARD TWO

PREFORMED PACKINGS (7)

AND HYDRAULIC O-RING (8).

3. REMOVE CAP (3).

a. Using hammer and punch, rotate

cap (3) to the right. Rotate until pry

bar can be placed under a corner (4)

of cap.

b. Using pry bar under cap (3), pry

up cap and lift off.

CAUTION

Failure to clean area around access cover can

result in damage to transmission.

6. REMOVE ACCESS COVER (9)

AND GASKET (10).

a. Remove 10 screws (11) and lock

washers (12). Discard lock washers.

b. Lift off cover (9)

c. Remove and discard gasket (10).

GO TO NEXT PAGE

3-33