TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 282 of 933

TM 9-2520-270-34

21. REPAIRER AND HELPER POSITION

STEERING ARM (1).

a.

b.

Repairer and helper remove controller

assembly (2) from workbench, turn

over, and hold top side up.

While holding controller assem-

CAUTION

Use care when lifting controller to prevent

damage. Keep hands free of internal controller

parts. Do not lower controller onto housing

bly (2), position steering arm (1)

so that it is evenly alined with

opening.

unless valve assemblies are all the way in

piston assemblies. Damage to equipment-can

occur.

22. ALINE PIN (3) AND LINK (4).

a. Repairer and helper partially lower

controller assembly (2) onto trans-

mission (5), and aline pin (3) with

link (4) by looking through plug

hole (6).

b. Stop lowering controller assembly (2).

23. REPAIRER AND HELPER INSTALL

CONTROLLER ASSEMBLY (2).

a. Aline steering arm (1).

b. Aline pins (7) with holes (8) on

housing (5) and lower controller

assembly (2).

c. Cover hole (9) with clean rag.

3-38