TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 291 of 933

TM 9-2520-270-34

CAUTION

Do not deform shaft or housing. Equipment

can be damaged.

3. REMOVE AND DISCARD SEAL (1).

a. Using hammer and drive punch, deform

seal (1) so that pliers can grip it.

b. Grasp seal (1) and pull from

seal well (2).

c. Discard seal (1).

4. CLEAN WASHERS, SEAL WELLS,

AND SHAFTS. See page 2-2.

5. INSPECT WASHERS, SEAL WELLS,

AND SHAFTS. See page 2-5.

ASSEMBLE

6. INSERT NEW SEAL (1).

a.

b.

c.

d

Coat new seal (1) with transmission oil.

Place shaft-seal starter (3) over

shaft (4).

Slide seal (1) over shaft-seal starter (3)

with lip (5) facing down.

Tap seal (1) into seal well (2) until

seated flush. Remove shaft-seal

starter (3).

7. INSTALL NEW RETAINING RING (6).

a. Install washer (7).

b. Using retaining-ring pliers, install

new retaining ring (6).

END OF TASK

Change 3

3-45