TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 294 of 933

TM 9-2520-270-34

6. REMOVE SPRING (1) AND TWO

HELlCAL SPRINGS (2).

a.

b.

c.

d.

Unhook and remove spring (1).

Unhook outer ends of each spring (2)

from two pins (3).

Unhook and remove inner ends of

each spring (2) from steering arm (4).

Discard springs (2).

Remove steering arm (4) from punch.

7.

3-48

INSPECT STEERING ARM (4) FOR

CRACKS IN BRAZE JOINTS AND

SURFACE DAMAGE.

a. Replace steering arm (4) if damaged.

8. CHECK STEERING ARM (4).

a. Using indicator caliper, measure

distance (5) between edges (6).

b. Replace steering arm (4) if

measurement is greater than

2.406 inches (61.11 mm).

9. CLEAN STEERING ARM ASSEMBLY.

a. Clean assembly and hardware. See

page 2-2.

10. INSPECT STEERING ARM ASSEMBLY.

a. Inspect assembly and hardware. See

page 2-5.