TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 775 of 933

TM 9-2520-270-34

43. INSTALL DIPSTICK TUBE

ASSEMBLY (1) AND DIPSTICK (2).

a. Feed dipstick tube assembly (1)

through hole (3). Place lower end (4)

of dipstick tube in hole (5).

b. Install dipstick (2)

c. Position flat side of clamp (6)

away from main housing and install

screw (7).

46. SECURE HOSE ASSEMBLY (9).

a. Position two clamps (10).

b. Using 3/8-inch drive ratchet handle

and 5/32-inch socket wrench attach-

ment, install two new screws (11).

47. USING 3/8-lNCH DRIVE TORQUE

WRENCH WITH EXTENSION AND

5/32-lNCH SOCKET WRENCH ATTACH-

MENT, TORQUE TWO SCREWS (11)

TO 35-45 in-lb (40-52 cmkg).

44. USING 3/8-lNCH DRIVE TORQUE

WRENCH WITH EXTENSION, AND

7/16-lNCH SOCKET, TORQUE

SCREW (7) TO 110-120 in-lb

(127-138 cmkg).

45. INSTALL NEW LOCKWIRE (8).

a. Using wire-twister pliers, install

Iockwire (8) through screw (7) and

around dipstick tube assembly (1)

and clamp (6).

48. INSTALL TWO NEW LOCKWIRES (12).

a. Using wire-twister pliers, install lock-

wires (12) through two screws (11)

and around hose assembly (9).

GO TO NEXT PAGE

Change 1

4-439