TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 768 of 933

TM 9-2520-270-34

12. REMOVE DIPSTICK (1) AND DIPSTICK

TUBE ASSEMBLY (2).

a. Using wire-twister pliers, remove and

discard Iockwire (3).

b. Using 3/8-inch drive ratchet handle

with extension and 7/16-inch

socket, remove screw (4).

c, Remove dipstick (1) and dipstick

tube assembly (2) with clamp (5).

14. INSPECT TWO PADS (9) ON

EACH BRAKE ASSEMBLY (6).

a.

b.

4-434

Inspect two pads (9) on each brake

assembly (6) for damage, See page 2-5.

If no brake pads (9) are damaged, go

to step 15. If any brake pad is

damaged, replace two brake assem-

blies (6) and go to step 16.

13. REMOVE TWO SECOND RANGE BRAKE

ASSEMBLIES (6).

a. Remove 10 self-locking bolts (7)

and washers (8). Discard bolts.

15. CHECK TWO BRAKE ASSEMBLIES (6).

a. Using depth gage, measure

height (10) of two pads (9) on

each brake assembly (6).

b. Replace two brake assemblies (6) if

any measurement is less than

0.100 inch (2.54 mm).

Change 1

b.

Remove two brake assemblies (6).