TM-9-2520-270-34

HYDROMECHANICAL CROSSDRIVE, TRANSMISSION HMPT 500 AND TRANSMISSlON CONTAINER ASSEMBLY

TECHNICAL MANUAL; DIRECT AND GENERAL SUPPORT MAINTENANCE

NOVEMBER 1984

TM-9-2520-270-34 - Page 770 of 933

TM

9-2520-270-34

22. REMOVE ELBOWS (1) AND (2).

a. Remove elbow (1) and preformed

packing (3) from brake (4).

Discard packing.

b. Remove elbow (2) and preformed

packing (5) from brake (6).

Discard packing.

27. INSPECT TWO PADS (7) ON

EACH BRAKE (4) AND (6).

a. Inspect two pads (7) on each brake (4)

and (6) for damage, See page 2-5.

b. If pads (7) are damaged, go to

step 28. If not, go to step 29.

28. REPAIR SINGLE DISK BRAKES (4)

AND (6). See task REPAIR

SECOND RANGE SINGLE DISK

BRAKES, Page 4-441.

23.

IF MEASUREMENT IN STEP 11

WAS WITHIN 0.021-0.060 INCHES

(0.533-1.524 mm), GO TO STEP 27.

IF NOT, GO TO STEP 24.

24.

IF SECOND RANGE BRAKE

ASSEMBLIES WERE REPLACED IN

STEPS 14 OR 15, GO TO STEP 25.

IF NOT, GO TO STEP 27.

25. REPAIR SINGLE DISK BRAKES (4)

AND (6). See task REPAIR

SECOND RANGE SINGLE DISK

BRAKES, page 4-441.

26. GO TO STEP 29.

29. INSTALL ELBOW (1) AND PREFORMED

PACKING (3). See task INSTALL ELBOW

(45° AND 90°), page 2-179.

4-436

Change 3

INSTALL