TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 154 of 620

TM 9-2520-272-40

0020

INSTALL BRAKE COOLANT VALVE ASSEMBLY COMPONENTS

NOTE

Make sure that the right cover assembly is turned so that the internal side points up.

Early models of the X200-4A Transmission have a two-piece brake coolant valve that has a

brake coolant valve stem (Figure 2, Item 7) and a coolant valve (Figure 2, Item 8). Later

models of the X200-4A Transmission have a product-improved, one-piece brake coolant valve

(Figure 2, Item 5). Each time a two-piece conf guration is found (Figure 2, Item 7) and (Figure

2, Item 8), you must replace it with the newer one-piece brake coolant valve conf guration

(Figure 2, Item 5).

1. Install new packing retainer (Figure 3, Item 6) on one-piece brake coolant valve (Figure 3, Item 5).

2. Apply petrolatum on packing retainer (Figure 3, Item 6).

3. Install one-piece brake coolant valve (Figure 3, Item 5) in bore (Figure 3, Item 9) of end cover housing, packing

retainer end f rst. Push brake coolant valve until it touches the bottom of the bore.

4. Install large spring (Figure 3, Item 4) on one-piece brake coolant valve (Figure 3, Item 5).