TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 160 of 620

TM 9-2520-272-40

0021

INSTALL LEFT BRAKE APPLY SHAFT

CAUTION

Put protective material, such as masking tape, on the splines. If the shaft goes through the seal

without protection, the splines on the shaft will cause damage to the seal.

NOTE

Make sure that the right cover assembly is turned so that the internal side points up. Put

the right cover assembly on wooden blocks.

If there is tape on splines, put petrolatum on tape before you install shafts.

1. Apply petrolatum to washer (Figure 4, Item 7).

2. Install washer (Figure 4, Item 7) on the left brake apply shaft (Figure 4, Item 1).

3. Clean the spline end of the left brake apply shaft (Figure 4, Item 1).

4. Wind masking tape around the spline and end of left brake apply shaft (Figure 4, Item 1).

5. Apply petrolatum on tape on the left brake apply shaft (Figure 4, Item 1).

6. Put the taped end of the left brake apply shaft (Figure 4, Item 1) above the bearing (Figure 4, Item 8) in the

right cover assembly (Figure 4, Item 5).