TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 168 of 620

TM 9-2520-272-40

0023

REMOVE RIGHT BRAKE SUPPORT ASSEMBLY

NOTE

Make sure that the right cover assembly is turned upside down.

When the right brake support assembly is removed, the following parts may come out with the

support, or they may remain in the right cover assembly: rotating cam, eight balls, brake

adjusting links, cam seal rings, and right brake apply cam shaft.

Two bearing races and a needle bearing will remain in right brake support assembly after

completion of this task. The races require application of heat for removal. Refer to Repair Right

Brake Support Assembly (WP 0024) for removal of races and needle bearings.

1. Remove two bolts (Figure 1, Item 4) and two washers (Figure 1, Item 5) from right brake support assembly

(Figure 1, Item 8).

2. Remove 12 remaining bolts (Figure 1, Item 6) and 12 washers (Figure 1, Item 7) from around perimeter

of right brake support assembly (Figure 1, Item 8).

3. Pry right brake support assembly (Figure 1, Item 8) off right cover assembly (Figure 1, Item 9) using two pry

bars (Figure 1, Item 1) positioned approximately 180 degrees apart.

4. Remove right brake support assembly (Figure 1, Item 8) from right cover assembly (Figure 1, Item 9).

5. Remove O-ring (Figure 1, Item 3) from oil transfer (lube) tube (Figure 1, Item 2). Discard O-ring (Figure

1, Item 3).