TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 329 of 620

TM 9-2520-272-40

0041

3. Remove bolt (Figure 3, Item 10) and washer (Figure 3, Item 9).

4. Remove the remaining 24 bolts (Figure 3, Item 6) and washers (Figure 3, Item 7) that hold the input housing

(Figure 3, Item 3) to the transmission (Figure 3, Item 8).

5. Install 3/8-16 x 2-3/4 inch jack bolt (Figure 4, Item 11) in jack bolt hole (Figure 4, Item 14) near center at top

end of input housing (Figure 4, Item 3).

6. Install 3/8-16 x 1-1/4 inch jack bolt (Figure 4, Item 12) in jack bolt hole (Figure 4, Item 13) near center at bottom

end of input housing (Figure 4, Item 3).

7. Equally tighten jack bolts (Figure 4, Item 11) and (Figure 4, Item 12) until input housing (Figure 4, Item 3)

loosens from transmission (Figure 4, Item 8).

8. Remove jack bolts (Figure 4, Item 11) and (Figure 4, Item 12) from input housing (Figure 4, Item 3).

9. Remove input housing (Figure 4, Item 3) from transmission (Figure 4, Item 8).