TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 322 of 620

TM 9-2520-272-40

0039

NOTE

Remove or install the external-splined ring gear only when the external-splined ring gear fails or

when the converter pump cover assembly is replaced.

28.Install the ring gear (Figure 23, Item 5) over six studs (Figure 23, Item 7) on top of the converter pump cover

assembly (Figure 23, Item 1).

29.Using plastic-faced hammer, tap ring gear (Figure 23, Item 5) until it is installed on the converter pump cover

assembly (Figure 23, Item 1).

30.Use pry bar (Figure 23, Item 6) between two studs (Figure 23, Item 7) on top of the converter pump cover

assembly (Figure 23, Item 1) to keep cover and ring gear (Figure 23, Item 5) from turning.

31.Install six new f ex disk nuts (Figure 23, Item 4) on the studs (Figure 23, Item 7) that attach the ring gear (Figure

23, Item 5) to the converter pump cover assembly (Figure 23, Item 1).

32

.Torques

ixnu

ts(F

igure23

,I

tem4)to41to44lb-

f

t(56to60N·m)

.