TM-9-2520-272-40

TM-9-2520-272-40 - Page 365 of 620

TM 9-2520-272-40

0045

3. Position left brake support (Figure 3, Item 3) on wooden blocks (Figure 3, Item 9) as shown in Figure 3.

4. Loosen two retainer bolts (Figure 3, Item 7). Loosen three stationary cam bolts (Figure 3, Item 5). Loosen

bolts (Figure 3, Item 7) and (Figure 3, Item 5) until bolt heads are approximately 0.25 in. (6.5 mm) out of holes

in left brake support (Figure 3, Item 3).

5. Tap bolt heads (Figure 3, Item 7) and (Figure 3, Item 5) to loosen retainer and stationary cam located below left

brake support (Figure 3, Item 3).

6. Remove two bolts (Figure 3, Item 7) and two washers (Figure 3, Item 8) from left brake support (Figure 3,

Item 3). Remove three bolts (Figure 3, Item 5) and three washers (Figure 3, Item 6) from left brake support

(Figure 3, Item 3).