TM-9-2520-272-40
CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A
TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL
FEBRUARY 2012
TM-9-2520-272-40 - Page 374 of 620
TM 9-2520-272-40
0045
8. Apply petrolatum to thrust washer (Figure 15, Item 37) and install it on output carrier (Figure 15, Item 32).
9. Install output carrier (Figure 15, Item 32) and thrust washer (Figure 15, Item 37) into brake clutch drum (Figure
15, Item 36).
10.Install retaining ring (Figure 15, Item 35) to keep output carrier (Figure 15, Item 32) in position in brake clutch
drum (Figure 15, Item 36).
11. Turn the components assembled in Step 10 upside down, and install the assembly into the center housing.
12.Apply petrolatum to thrust washer (Figure 16, Item 31) and install in bottom of spur gear cluster (Figure 16,
Item 30).
13.Install gear cluster (Figure 16, Item 30) and thrust washer (Figure 16, Item 31) into clutch drum (Figure 16,
Item 36).
14.Soak six friction plates (Figure 16, Item 49) in lubricating oil for two minutes before installation. Install one
friction plate (Figure 16, Item 49), then one reaction plate (Figure 16, Item 48).
15.Repeat Step 14 until all six friction plates (Figure 16, Item 49) and (Figure 16, Item 47) and all f ve reaction
plates (Figure 16, Item 48) and (Figure 16, Item 46) are installed.
Back to Top
