TM-9-2520-272-40

CROSS-DRIVE TRANSMISSION WITH CONTAINER MODEL X200-4A

TECHNICAL MANUAL; SUSTAINMENT MAINTENANCE MANUAL

FEBRUARY 2012

TM-9-2520-272-40 - Page 380 of 620

TM 9-2520-272-40

0045

40.Turn support (Figure 21, Item 3) over and position on 2 x 4 x 24 inch soft wood lumber wooden blocks.

41.Install control cam (cam shaft) (Figure 21, Item 13) into support (Figure 21, Item 3).

42.Install retaining ring (Figure 21, Item 14) onto cam shaft (Figure 21, Item 133).

43.Turn support (Figure 21, Item 3) over and position on 2 x 4 x 24 inch soft wood lumber wooden blocks.

44.Install control cam (stop) (Figure 21, Item 15) onto cam shaft (Figure 21, Item 13).

45.Install torsion helical spring (Figure 21, Item 16) onto cam shaft (Figure 21, Item 13). Engage straight end

of spring (Figure 21, Item 16) behind pin in support (Figure 21, Item 3), Engage hook end of spring (Figure

21, Item 16) with hole in stop.

46.Install washer (Figure 21, Item 17) onto cam shaft (Figure 21, Item 13).

47.Install retaining ring (Figure 21, Item 18) against washer (Figure 21, Item 17).