TM-9-2815-200-35

ENGINE, WITH CONTAINER:TURBOSUPERCHARGED, DIESEL ,FUEL INJECTION ,90-DEGREE “V” TYPE, AIR - COOLED ,12 - CYLINDER , ASSEMBLY ;MODELS AVDS-1790-2M (2815-856-4996), AVDS-1790-2A AND AVDS-1790-2AM (2815-856-9005)

TECHNICAL MANUAL; DIRECT SUPPORT, GENERAL SUPPORT AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

TM-9-2815-200-35 - Page 506 of 779

6-62. Overhaul of Generator Air Intak e

and Exhaust Tubes and Associate d

Part s

a. Disassembly.

Disassemble generator ai r

intake tube assembly following instruction s

which accompany figure 6-250. The generato r

boot exhaust tube, and associated parts wer e

disassembled during disassembly of engine ,

Chapter 5 .

b. Cleaning, Inspection, and Repair.

Refer t o

paragraphs 6-2 through 6-4 .

c.

Assembly.

Refer to figure 6-250. Th e

generator boot, exhaust tube, and associate d

parts are assembled during engine assembly ,

Chapter 7 .

Disassemble

1. Remove six cap screws (A) and lock washers attaching

screen to hose elbow.

2. Remove screen (B).

3. Remove and discard screen gasket (C).

4. Loosen two hose clamps (D) and remove hose from

generator air intake tube and elbow. Remove clamps

from hose.

Assemble

1. Position two hose clamps (D) on hose. Position hose

on elbow and generator air intake tube and tighten hose

clamps.

2. Position a new screen gasket (C) on elbow.

3. Position screen (B) on elbow.

4. Install six cap screws (A) and lock washers securing

screen to elbow.

Figure 6-250. Disassembling or assemblin g

generator air intake tube assembly .

6-212