TM-9-2815-205-24
6V53/6V53T ENGINES, DIESEL WITH CONTAINERS; MODEL 5063-5299, MODEL 5063-5392, MODEL 5063-5393 AND MODEL 5063-539L
TECHNICAL MANUAL; FIELD AND SUSTAINMENT MAINTENANCE
FEBRUARY 2013
TM-9-2815-205-24 - Page 648 of 856
CLEANING
WARNING
Cleaning solvent is TOXIC and flammable. Wear protective goggles and gloves;
use only in a well-ventilated area; avoid contact with skin, eyes, and clothes; and
do not breathe vapors. Keep away from heat or flame. Never smoke when using
cleaning solvent. Failure to comply may result in injury, illness, or death to
personnel.
Compressed air used for cleaning purposes will not exceed 30 PSI (207 kPa). Use
only with protective equipment (goggles, face shield, gloves, etc.). Failure to
comply may result in injury to personnel.
Clean front cover with cleaning solvent and dry with compressed air.
END OF TASK
INSPECTION-ACCEPTANCE AND REJECTION CRITERIA
1.
Inspect seals and seal spacers for wear or damage.
2.
Inspect pulleys for evidence of cracks, chips, or broken areas. A crack, chip, or broken area on the belt
grooves is acceptable provided the damage does not exceed 305 arc and the pulley is installed on the
right camshaft.
END OF TASK
ASSEMBLY
1.
Install new oil seals in following manner:
NOTE
If outside diameter of oil seal is not precoated, coat seal bore in front cover with
sealing compound.
a.
Place inner face of front cover (Figure 3, Item 3) on wooden blocks.
b.
Place new oil seal (Figure 3, Item 12) on cover (Figure 3, Item 3) with lip of seal pointing toward inner
face of cover. Using seal inserter (Figure 3, Item 13), press seal into cover until flush with bottom
of counterbore.
c.
If necessary, remove excess sealing compound from cover and seal.
2.
If removed, apply sealing compound to two new expansion plugs (Figure 3, Item 10) and press into front
cover (Figure 3, Item 3) until flush with face of bore.
TM 9-2815-205-24
0090
0090-4
Back to Top
