TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 295 of 596

TM 9-2815-205-34

3-48. CAMSHAFTS, CAMSHAFT GEARS, AND IDLER GEAR REPLACEMENT (Cont)

b. Disassembly

(1)

(2)

(3)

(4)

NOT E

●

Tag camshafts and gears prior

to disassembling.

●

Use same procedure for right

and left camshafts.

●

When press is not available,

use camshaft gear puller (20) to

remove camshaft gears.

On models 5063-5392, 5063-5393,

5063-539F, and 5063-539L, remove two

bolts (21) and balance weight (22) from

camshaft gear (14).

Remove camshaft gears in the following

manner:

(a) Support camshaft (23) and camshaft

gear (14) under gear.

NOT E

Place wooden block under

lower end of camshaft to pre-

vent thread damage when cam-

shaft is pressed from camshaft

gear.

(b)

(c)

Place a short 3/4 inch diameter brass

rod (24) on camshaft (23). Press

camshaft out of camshaft gear (14).

Remove spacer plate (18), spacer

sleeve (25), and Woodruff key (26)

from camshaft (23).

If necessary, press bearing (27) from idler

gear (28). Discard bearing.

Remove two camshaft end plugs (29) from

camshaft (23) in the following manner:

CAUTION

Use care when handling cam lobes or journals of shaft. Lobe and journal surfaces are

precision machined and must not be damaged.

3-166

Change 1