TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 298 of 596

TM 9-2815-205-34

e. Assembly

(1)

(2)

(3)

(4)

(5)

(6)

NOTE

Use same procedure

and right camshaft.

for left

Coat plugs (29) with sealing compound

and press into ends of camshaft (23) to a

depth of 1.940 inches.

.

,

CAUTION

Camshafts improperly installed

may cause severe engine

damage.

NOTE

Camshafts are stamped at

ends for location. Camshaft

marked “RH-R BANK” goes in

right bank,

and camshaft

marked “RH-L BANK” goes in

left bank. Install camshafts with

markings at rear of engine.

Install spacer sleeve (25) and Woodruff

key (26) to rear of camshaft (23).

Lubricate spacer plate (18) with engine oil

and place over spacer sleeve (25).

NOTE

Camshaft gear with timing

marks of two circles and two

triangles goes on right cam-

shaft.

Align keyway in camshaft gear (14) with

Woodruff key in camshaft. Place

camshaft gear on camshaft (23).

Support camshaft (23) and place 1 1/2-

inch sleeve (36) on top of camshaft gear

(14). Press camshaft gear tight against

spacer sleeve (25).

Measure clearance between spacer plate

(18) and camshaft (23). Clearance should

be 0.008-0.015 inch with new parts and a

maximum of 0.021 inch with used parts.

3-169