TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 289 of 596

TM 9-2815-205-34

3-46. UPPER FRONT COVER REPLACEMENT (Cont)

•

NOT E

Several front cover fastening bolts are installed with installation of clips, water pump

idler pulley assembly, solenoid bracket, and fan support bracket (refer to para 3-10,

3-11, 3-12, 3-13, and 3-39).

See Table 3-3 for bolt sizes and locations.

(2) Install upper front cover (3), flatwashers (6), lockwashers (5), and bolts (4) on cylinder block.

Torque bolts to 30-35 lb-ft (41-47 N

.

m).

(3) Apply grease to outside diameter of two seal spacers (9) and slide in position on camshafts.

(4) Install two Woodruff keys (8) in slot at end of camshafts.

(5) Align keyway in pulley with Woodruff key (8). Slide two pulleys (2) on ends of camshafts.

NOT E

•

To tighten and torque camshaft nuts with flywheel housing on engine, secure flywheel

or crankshaft to prevent camshaft gears from turning.

Ž

To tighten and torque camshaft nuts with flywheel housing removed, wedge a rag

between camshaft gears.

(6) Install two nuts (1) on camshafts and torque to 300-325 Ib-ft (407-441 N-m).

3-160