TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 279 of 596

TM 9-2815-205-34

3-45. LOWER FRONT COVER, OIL PUMP, AND OIL PRESSURE REGULATOR REPLACEMENT

(Cont)

(2) Front cover assembly:

(a)

Remove plug (19), plug (20), two copper washers (21), two springs (22), and two sleeves

(23) from sides of front cover (6). Discard copper washers.

NOT E

Models 5063-5299 and 5063-5398 do not use cover plate (24) or fastening hardware.

(b) Remove two screws (25), two Iockwashers (26), cover plate (24), and gasket (27) from

bottom of front cover (6). Discard gasket and Iockwashers.

(c)

For model 5063-5299: if necessary, remove two plugs (28) and plug (29) from front cover

(d) For all except model 5063-5299: if necessary, remove four plugs (28), plug (29), plug (30),

and cup plug (31) from front cover (6). Discard cup plug.

(e) Drill two holes in opposite sides of casing of oil seal (32). Thread metal screws with flat

washers into casing. Pry against flat washers and remove oil seal. Discard seal.

NOT E

Model 5063-5299 does not use sleeve bearing (33).

(f) Press or drive sleeve bearing (33) from bore in front cover (6). Discard bearing.

3-150