TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 272 of 596

TM 9-2815-205-34

b. Cleaning/Inspection

Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles

and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and

clothes. Do not breathe vapors. Do not use near open flame or excessive heat.

The flash point is 100-138°F (38-50°C). If you become dizzy while using cleaning

solvent, get fresh air immediately and seek medical aid. If contact with eyes is

made, wash with water and get medical aid immediately.

Compressed air used for cleaning purposes will not exceed 30 PSI. Use only with

effective chip guarding and personal protective equipment (goggles/shield,

gloves, etc.)

(1) Clean flywheel housing with cleaning solvent and dry with compressed air.

(2) Inspect flywheel housing for cracks or damage.

c. Installation

(1) On models 5063-5393 and 5063-539L, install elbow (33) in left side of flywheel housing (2).

(2) If removed, install dowel (32) in upper part of flywheel housing (2).

(3) On models 5063-5299,5063-5392, 5063-5393, and 5063-539L, install gasket (30), cover (29),

three Iockwashers (28), and three bolts (27) on left side of flywheel housing (2). Torque bolts to

13-17 Ib-ft (18-23 NŽm).

(4) On models 5063-5395,5063-5398, and 5063-539F, install gasket (30), drain adapter (31), three

Iockwashers (28), and three bolts (27) on left side of flywheel housing (2). Torque bolts to 13-17

Ib-ft (18-23 N•m).

Change 1

3-143