TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 265 of 596

TM 9-2815-205-34

3-43. CYLINDER HEAD ASSEMBLY REMOVAL/INSTALLATION (Cont)

CAUTION

Ensure all gaskets, seals, sleeves, and seal strip are in place before installing cylinder

head. A fold or twist of the seal strip can cause a leak.

(7) Lift cylinder head above cylinder block and lower over guide studs (6). Lower head to 1/2 inch

from surface of cylinder block. Check position of all gaskets, seals, sleeves, and seal strip and

then lower head onto block.

•

Ž

(8)

3-136

NOT E

Model 5063-5398 uses two lengths of cylinder head bolts for the right cylinder head,

three 7-3/8 inch bolts and five 6-1/2 inch bolts. Longer bolts go in ends of cylinder

heads except at rear outboard position.

Model 5063-5398 uses two lengths of cylinder head bolts for the left cylinder head, four

7-3/8 inch bolts and four 6-1/2 inch bolts. Longer bolts go in ends of cylinder heads.

Apply International Compound No. 2 to cylinder head bolt threads and underside of bolt head.

Install six bolts (5) through cylinder head and thread into cylinder block until bolt heads contact

cylinder head.