TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 259 of 596
TM 9-2815-205-34
3-42. INJECTOR CONTROL TUBE AND THROTTLE DELAY REPLACEMENT (Cont)
(2) Inspect components for excessive wear, cracks, or damage. Replace if necessary.
(3) Inspect yield springs and return springs for wear and fractures.
d. Assembly
(1) Left
(a)
(b)
(c)
(d)
(e)
(f)
injector control tube assembly
Install return spring (18) on control tube (16) and against rear bracket (19).
Install two of right-hand helix springs (14) and two control levers (7) on control tube (16)
with control levers facing rear of control tube.
Install left-hand helix yield spring (15)
and control lever (7) on control tube
(16) with control lever facing rear of
control tube.
Connect curled end of two yield
springs (14) and yield spring (15) to
three rack control levers (7) and roll
yield springs into notch or slots in
control tube (16). Turn three
adjusting screws (13) with locknuts
(12) far enough into slots to position
levers on control tube.
Connect curled end of control tube
return spring (18) to rack control
lever (7) and extended end of spring
behind rear bracket (19).
Install bracket (6) to front of control
tube (16).
(2) Right injector control tube assembly
(a)
(b)
(c)
Install control lever (7) and left-hand
helix yield spring (15) on control tube
(17) with control lever facing front of
control tube.
Install two of right-hand helix yield
springs (14) and control levers (7) on
control tube (17) with control lever
facing front of control tube.
Connect curled end of two yield
springs (14) and yield spring (15) to
three rack control levers (7) and roll
yield springs into notch or slots in
control tube (17). Turn three
adjusting screws (13) with locknuts
(12) far enough into slots to position
levers on control tube.
3-130
Back to Top
