TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 260 of 596
TM 9-2815-205-34
(d)
Install return spring (18) and bracket (6) at front of control tube (17). Connect curled end of
return spring to rack control lever and extended end of spring behind bracket.
(3) Throttle delay assembly
(a)
(b)
(c)
(d)
Install joint (28) and self-locking nut (29) on piston (30). Tighten nut.
Install link (23) and self-locking nut (27) on joint (28). Tighten nut.
If removed, install screw (26) and self-locking nut (25) on bracket (24). Tighten nut until
width between legs is 1 7/16 inches.
Install link (23), two screws (22), two bushings (21), and two self-locking nuts (20) on
bracket (24). Tighten nuts.
e. Installation
NOT E
Steps (1) and (4) apply to throttle delay assembly used on right bank of all except model
5063-5299.
Legs on lever assembly (4) must face downward and be inboard of control tube.
(1)
(2)
(3)
(4)
Slide throttle delay piston and linkage assembly (10) in bore of housing (11).
Place injector control tube assembly (9) on cylinder head. Engage control levers (7) with injector
control racks (8) and place end brackets (6 and 19) over mounting holes in cylinder head. Install
four screws (5) through end brackets into cylinder head. Torque screws to 120-144 lb-in (14-16
N•m).
Check control tube to ensure it moves
freely in end brackets (6 and 19). If
necessary, tap control tube lightly to align
bearing in brackets.
NOT E
Final torque of nuts (1) is done
during throttle delay adjustment
of tune-up (para 4-4).
Install U-bolt (3) around bottom of control
tube and through lever assembly (4).
Install two Iockwashers (2) and two nuts
(1) on U-bolt. Tighten nuts snug.
END OF TASK
FOLLOW-ON MAINTENANCE
Para Description
3-31 Connect throttle control rods.
3-20 Install rocker arm covers (models 5063-5299 and 5063-5398)
3-21 Install rocker arm covers (models 5063-5392, 5063-5393, 5063-539F, and 5063-539L)
3-22 Install rocker arm covers model 5063-5395).
Change 1
3-131
Back to Top
