TM-9-2815-205-34
ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L
TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE
AUGUST 1992
TM-9-2815-205-34 - Page 258 of 596
TM 9-2815-205-34
(b)
.
(c)
(d)
(e)
(f)
Loosen locknut (12) and adjusting
screw (13) from control lever (7).
Disconnect yields ring (14 or 15)
from each control ever (7). Roll yield
springs out of slots and notches of
control tube (16 or 17).
Disconnect return spring (18) from
bracket (19) and control lever (7) at
rear of left control tube (16) or from
bracket (6) and control lever at front
of right control tube (17).
For right control tube assembly,
remove bracket (6) from front of tube.
Slide three control levers (7), two
yield springs (14), yield spring (15),
and return spring (18) off front of
control tube (16 and 17).
(2) Throttle delay assembly
(a)
(b)
(c)
(d)
Remove two self-locking nuts (20),
two bushings (21), two screws (22),
and link (23) from bracket (24).
Discard nuts.
If necessary, remove self-locking nut
(25) and machine screw (26) from
bracket (24). Discard nut.
Remove self-locking nut (27) and link
(23) from joint (28). Discard nut.
Remove self-locking nut (29) and
joint (28) from piston (30). Discard
nut.
c. Cleaning/Inspection
•
Dry cleaning solvent P-D-680 is toxic and flammable. Wear protective goggles
and gloves and use in a well-ventilated area. Avoid contact with skin, eyes, and
clothes. Do not breathe vapors. Do not use near open frame or excessive heat.
The flash point is 100-138 Degrees F (38-50 Degrees C). If you become dizzy
while using cleaning solvent, get fresh air immediately and seek medical aid. If
contact with eyes is made, wash with water and get medical aid immediately.
Ž
Compressed air used for cleaning purposes will not exceed 30 PSI. Use only
with effective chip guarding and personal protective equipment (goggles/shield,
gloves, etc.)
(1) Wash components with cleaning solvent and dry with compressed air.
3-129
WARNING
Back to Top
