TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 281 of 596

TM 9-2815-205-34

3-45. LOWER FRONT COVER, OIL PUMP, AND OIL PRESSURE REGULATOR REPLACEMENT

(Cont)

e. Assembly

(1) Front cover assembly

NOT E

Model 5063-5299 does not use

sleeve bearing (33).

(a)

Coat bore of front cover (6) with

retaining adhesive and position

sleeve bearing (33) in cover with split

line at bottom. Press bearing into

cover until flush to 0.015 inch below

outer face.

NOT E

If oil seal is not precoated,

apply sealing compound to

outside diameter of metal

casing.

(b)

(c)

(d)

(e)

Position oil seal (32) in front cover (6)

with seal lip pointed toward inner face

of cover.

Using oil seal installer (35), press oil

seal (32) into front cover (6) until

flush with outside face.

For all except model 5063-5299: if removed, install four plugs (28), plug (29), plug (30),

and cup plug (31) into front cover (6).

For model 5063-5299: if removed, install two plugs (28) and plug (29) into front cover (6).

NOT E

Models 5063-5299 and 5063-5398 do not use cover plate (24) or fastening hardware.

(f) Install gasket (27), cover plate (24), two Iockwashers (26), and two screws (25) to bottom

of front cover (6). Torque screws to 13-17 Ib-ft (18-23 NŽm).

NOT E

Install plug marked “R” on left side of front cover and plug marked “X” on right side of

front cover (as viewed from the front).

(g) Install two sleeves (23), two springs (22), two copper washers (21), plug (19), and plug

(20) in sides of front cover (6). Torque plugs to 30-40 Ib-ft (41-54 N•m).

3-152