TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 288 of 596

TM 9-2815-205-34

(3) Inspect pulleys for evidence of cracks, chips, Or broken areas. A crack, chip, or broken area on

the belt grooves is acceptable provided the damage does not exceed 30° arc and the pulley is

installed on the right camshaft.

Assembly

(1)

(2)

(3)

Install oil seals in following manner:

NOT E

If outside diameter of oil seal

(12) is not precoated, coat seal

bore in front cover (3) with

sealing compound.

(a)

(b)

(c)

Place inner face of front cover (3) on

wooden blocks.

Place oil seal (12) on cover (3) with

lip of seal pointing toward inner face

of cover. Using seal installer (13),

press seal into cover until flush with

bottom of counterbore.

If necessary, remove excess sealing

compound from cover and seal.

If removed, apply sealing compound to

two cup plugs (11) and press into front

cover (3) until flush with face of bore.

If removed, press two dowel pins (10) into

front cover (3) until pins protrude 3/8 inch.

Installation

(1)

Install gasket (7) to upper front cover (3)

with gasket adhesive.

3-159

d.

e.