TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 395 of 596

TM 9-2815-205-34

d.

Compressed air used for cleaning purposes will not exceed 30 PSI. Use only

with effective chip guarding and personal protective equipment (goggles/shield,

gloves, etc.)

(5) Dry oil cooler with compressed air.

Assembly

(1)

(2)

(3)

(4)

(5)

If removed, install pipe plug (10) in bottom of oil cooler housing (5).

Place gasket (8) on oil cooler housing (5).

NOT E

Inlet

opening is marked

"FROM" on cover and "IN" on

oil cooler. Outlet opening is

marked "TO" on cover and

"OUT" on oil cooler. Oil coolers

must be installed in correct

position to prevent any foreign

particles and sludge from

entering engine or transmis-

sion.

Carefully place oil cooler (7) inside oil cooler housing (5).

NOT E

Do not install bolts in locations (A), (B), (C), and (D).

Install gasket (6), cover (4), six fiat washers (3), six lockwashers (2), and six bolts (1) on oil

cooler (7) and oil cooler housing (5). Torque bolts to 13-17 lb-ft (18-23 N·m).

if removed, install four pipe plugs (9) in cover (4).

END OF TASK

FOLLOW-ON MAINTENANCE

Para Description

2-17 Install engine/transmission oil cooler assembly.

3-265