TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 498 of 596

TM 9-2815-205-34

4-4. ENGINE TUNE-UP (Cont)

d. Injector Control Tube Adjustment

(1)

NOT E

Letter “R” or “L” indicates

injector location, right or left

bank, as viewed from rear of

en inc. Cylinder numbers start

at front of each bank.

Adjust No. 3L or 3R injector

control lever first to establish a

guide for adjusting remaining

injector control levers.

Ensure idle speed adjusting

screw is backed out or a false

fuel injector rack setting will

result.

Adjust injector control tubes

with the same governor cover

used on governor to ensure

proper injector control tube

adjustment.

Loosen idle speed locknut (23). Hold

locknut and turn idle speed adjusting

screw (22) until 1/2 inch of threads project

from locknut.

CAUTION

Cover oil drain hole in cylinder head with clean rag to prevent cotter pin and clevis pin

from falling into engine.

(2) Loosen six adjustment screw locknuts (33) and back out six adjusting screws (34). All six

injector control levers (35) should be loose on control tubes (15).

(3) Move linkage (36) connecting governor to control tubes. Linkage must not bind.

4-14