TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 489 of 596

(3) Install rocker arm covers (Refer to Para 3-20,3-21, and 3-22).

(4) Check and fill crankcase to proper level (Refer to applicable vehicle lubrication order).

e. Prelubrication of Turbocharger

(1) Disconnect oil supply line at turbocharger bearing (center) housing.

(2) Fill bearing housing cavity with oil while rotating assembly by hand to coat internal bearing

surfaces with oil.

(3) Connect turbocharger oil supply line.

f. Initial Start-up

CAUTION

Do not energize starter for more than 30 seconds at one time. Allow starter motor to

cool for two to three minutes between operations to prevent overheating and damage.

(1) Crank engine with governor in NO FUEL position until an oil pressure reading registers on

gage.

(2) Start and run engine at idle. Oil pressure gage should read 10 PSI (69 kPa) for adequate

lubrication.

END OF TASK

4-5/(4-6 blank)

TM9-2815-205-34