TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

  TM-9-2815-205-34 - Page 482 of 596

TM 9-2815-205-34
3-68. GOVERNOR REPAIR (Cont)
(3) Governor housing assembly
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
(l)
If removed, press two pins (66) into
top of governor housing (36) until pins
bottom out.
If removed, apply sealing compound
to two adapters (67) and tap into place
until they extend 1 7/16 inches beyond
governor housing (36).
If removed, press pin (69) into rear of
governor housing (36) until it extends
3/8 inch beyond housing.
If removed, press two pins (68) into
front of governor housing (36) until
they extend 7/16 inch beyond housing.
If removed, install plate (71) and two
drive screws (70) on governor housing
(36).
If removed, press pin (41) into
governor housing (36). Pin must
extend 1.055-1.060 inches above
housing for model 5063-5299 and
1.497-1.504 inches above housing on
all except model 5063-5299. Measure
pin using depth gage.
Support lower end of operating shaft
(54) in press. Start bearing (52) on
shaft, numbered side up, and press
bearing against shoulder on shaft
using a sleeve positioned against
inner race of bearing.
If removed, press pin (46) in operating lever (59) until it bottoms out on shoulder.
On models 5063-5299 and 5063-5398, install nut (60) and screw (61) in operating shaft
lever (59).
On models 5063-5395, 5063-5392, 5063-5393, 5063-539F, and 5063-539L
I
install bolt (62),
special nut (63), and nut (64) in operating shaft lever (59).
Start operating shaft lever assembly (58) on operating shaft (54) with flat on shaft in flat in
lever bore and pin (46) up. Using a sleeve, press lever tight against inner race of bearing
(52).
Insert lever, bearing, and shaft assembly (74) through bore inside governor housing (36).
Place shifter fork (57) on lower end of shaft with finished cam surfaces facing rear of
governor housing.
3-354
Change 1


Back to Top