TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 473 of 596

TM 9-2815-205-34

(13) Place turbine wheel assembly (19), wheel

shroud (22), center housing (2), and

backplate (25) upright in turbocharger

(14)

holding fixture.

With compressor wheel (21) at room

temperature, position it over shaft of

turbine wheel assembly (19).

Turn compressor wheel nut

with a double universal socket

to prevent bending turbine

wheel shaft.

(15)

(16)

(17)

(18)

(19)

Lubricate threads of turbine wheel

assembly (19) and wheel face on

compressor wheel (21) with engine oil.

Install self-locking nut (20). Torque nut to

125-150 lb-in (14-17 N

.

m) to seat

compressor wheel against thrust spacer.

Loosen self-lockin nut (20) and inspect

nut face and front face of compressor

wheel to ensure they are smooth and

clean.

Torque self-locking nut (20) to 35-55 lb-in

(4-6 N

.

m).

Turn self-locking nut (20) an additional

120-130 degrees.

Check bearing axial end play as follows:

(a)

(b)

(c)

Clamp center housing assembly in

soft-jawed vise.

Fasten magnetic base dial indicator

(41) to center housing with indicator

tip resting on end of rotating shaft on

compressor side.

Move shaft axially back and forth by

hand. Total indicator reading should

be between 0.003 and 0.010 inch.

Replace shaft assembly if readings

are not in limits.

3-345