TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 463 of 596

(17)

(18)

TM 9-2815-205-34

Remove four bolts (42) and four flat washers (43) used to temporarily fasten front end plate to

blower housing. Install gasket (5), cover (4), two spacers (3), two plates (2), and six screws (1)

on front of blower. Torque bolts to 20-25 Ib-ft (27-34 N·m).

CAUTION

Excessive protrusion of blower housing with respect to end plate will cause distortion of

housing when blower hold-down bolts are tightened and result in rotor to housing

contact.

Using depth gage, check relationship of front and rear blower end plates (6 and 30) to bottom

of blower housing (28). Protrusion of blower housing with respect to end plate must not be

more than 0.001 inch above or 0.004 inch below end plate.

(19) Installs spacer (15), coupling (14), retainer (13), and four self-locking bolts (12) on gear (16).

Torque bolts to 14-18 Ib-ft (19-24 N·m).

(20) Install drive coupling (10) and four self-locking bolts (9) on gear (11). Torque bolts to 8-10 Ib-ft

(11-14 N·m).

(21) If removed, install pipe plug (32) into side of each end plate (30 and 6).

3-335