TM-9-2815-205-34

ENGINE WITH CONTAINER; MODELS 5063-5299, 5063-5392, 5063-5393, 5063-5395, 5063-5398, 5063-539F, 5063-539L

TECHNICAL MANUAL; DIRECT SUPPORT AND GENERAL SUPPORT MAINTENANCE

AUGUST 1992

TM-9-2815-205-34 - Page 460 of 596

TM 9-2815-205-34

3-66. BLOWER REPAIR (Cont)

d. Assembly

NOT E

Identify rear end plate (30) by

governor lubrication oil hole (A)

drilled in outer face of plate.

Install blower seals (31) with

lips dry.

(1) Install seals in end plates as follows:

(a)

(b)

(c)

(d)

(e)

Place front end plate (6), seal

counterbores up, on press.

Lubricate outer diameter of seal (31)

with engine oil.

Place seal (31), lip facing down, in

counterbore. Using blower seal

installer (41), press seal until shoulder

of installer contacts end plate.

Repeat steps (b) and (c) for second

seal (31).

Repeat steps (a) thru (d) for rear end

plate (30).

(2)

(3)

(4)

Place front end late (6), inner face up,

on two wooden blocks. Install right rotor

(7) and left rotor (8), splined shaft ends

up, in end plate.

NOT E

Install blower housing in same

orientation as match marked

during removal for better rotor

to housing clearances.

Install blower housing (28) over rotors (7

and 8).

Place rear end plate (30) over rotor

shafts. Temporarily install eight flat

washers (42) and eight screws (43) on

front end plate (6) and rear end plate (30)

at blower housing (28). Tighten screws

until snug.

NOT E

Install shims (27) in same gear from which they were removed.

3-332